Saturday, January 30, 2010

Save Keyless Entry Remote Fob Clicker for 2006 Infiniti G35 - With Do-It-Yourself Programming


Key2YourHeart has many Fobs and Infiniti Gifts. The Fob makes entry and exit vey convenient.

Infiniti Three Button Key Fob Out of Box. New. Replaced when autostart was installed.

This is for QX4, QX56, FX35, FX45, I35, G35, G35 Coupe and many Nissan models.

Instuctions for programming are at the bottom of this page and will work most of th time,

They will work on vehicles that broadcast on this frequencies:

FCC ID : KBRASTU15

Model No:ASTU 15

Canada: 2111104208

Battery CR2025

2002 - 2004 Infiniti QX4

2003 - 2006 Infiniti FX35

2003 - 2005 Infiniti FX45

2003 - 2005 Infiniti G35

2003 - 2004 Infiniti M45

2003 - 2005 Infiniti I35

2004 - 2005 Infiniti QX56

We Guarantee the unit works and was not water damaged (flood cars)

You may need to bring the vehicle to your Infiniti store, these directions work most the time:

To enter the ID code, follow this procedure.

Entering "Setting mode":
(1) Close and lock all doors.

(2) Insert and remove the key from the ignition more than six times within 10 seconds. (The hazard warning lamp will then flash twice.) At this time, the original ID codes are eliminated.

ID code entry:
(3) Turn ignition key to "ACC" position.

(4) Push lock button on the new remote controller once (for example, if door is locked using the remote controller during this ID code entry enable state, a new ID code can be entered). At this time, the new ID code is entered. (The hazard warning lamp will then flash twice.)

Additional ID code entry
(5) If you need to activate additional remote controllers, unlock the driver's door, then lock again with door lock knob.

(6) Push lock button on the additional new remote controller once.

(7) This ID code entry enable state and setting mode remain until the driver's door is opened.

NOTE
If you need to activate more than two additional new remote controllers, repeat the procedure "Additional ID code entry" for each new remote controller.
If the same ID code that exists in the memory is input, the hazard warning lamps will flash twice but the entry will be ignored.
Entry of maximum four ID codes is allowed and any attempt to enter more will be ignored.
Any ID codes entered after termination of the "setting mode" will not be accepted. Additionally remote control signals will be inhibited when an ID code has not been entered during the "setting" mode.

Get more detail about Keyless Entry Remote Fob Clicker for 2006 Infiniti G35 - With Do-It-Yourself Programming.

No comments:

Post a Comment